Used QSC PowerLight 6.0 Audio Amplifiers
All in Great Condition
PowerLight 6.0
OUTPUT POWER, in watts
20 Hz–20 kHz
8Ù per channel 1400 (@ 0.1% THD)
4Ù per channel 2500 (@ 0.1% THD)
2Ù per channel 3250 (@ 0.1% THD)
EIA: 1 kHz @ 1% THD
8Ù per channel 1600
4Ù per channel 2800
2Ù per channel 3500
Bridged Mono:
16Ù, 1 kHz @ 1% THD 3200
8Ù, 1 kHz @ 1% THD 5600
4Ù, 1 kHz @ 1% THD 7000
DYNAMIC HEADROOM
0.77 dB at 4Ù
DISTORTION
THD 20 Hz–20 kHz <0.06%: 8Ù, 4Ù, & 2Ù, @ 10 dB below rated power
8 & 4Ù, 20 Hz–2 kHz <0.02%: 1400 W @ 8Ù; 2500 W @ 4Ù
2Ù, 20 Hz–2 kHz: <0.02%: 3250 W @ 2Ù
SMPTE-IM Less than 0.02%
FREQUENCY RESPONSE
20 Hz to 20 kHz, ±0.15 dB
(at 10 dB below rated output power) 2 Hz to 50 kHz, +0/-3 dB
DAMPING FACTOR
Greater than 2000 (1 kHz and below)
NOISE (unweighted)
107 dB below rated output (20 Hz to 20 kHz)
VOLTAGE GAIN
40× (32 dB)
INPUT SENSITIVITY, VRMS
rated power @ 8Ù 2.6 Vrms (+10.6 dBu)
rated power @ 4Ù 2.5 Vrms (+10.2 dBu)
INPUT IMPEDANCE
10 kΩ unbalanced
20 kΩ balanced
CONTROLS
Front: AC switch, Ch. 1 and Ch. 2 gain knobs, Ch. 1 and Ch. 2 clip limiter switches
Rear: Parallel/Stereo/Bridge switch, remote power supply enable terminals
INDICATORS (each channel)
PROTECT: Red LED CLIP: Red LED
STANDBY: Yellow LED -10 dB: Yellow LED
POWER: Green LED -20 dB: Yellow LED
SIGNAL: Green LED
CONNECTORS
Input: “Euro-style” barrier strip; Neutrik “Combo†XLR and ¼” (6.3 mm) TRS, tip and pin 2 positive
Output: “Touch-Proof†binding posts, 60A rated;
Neutrik Speakonâ„¢ connectors (1 per channel)
Data Port: HD 15 female connector for QSControl MultiSignal Processor
Manufacturer’s Link
http://media.qscaudio.com/pdfs/pl69user.pdf
Equipment List
4 – QSC PowerLight 6.0 Audio Amplifier
1 – Amp-rack
Leave a Reply